![]() Have you been able to test the KepServer driver on your development PC ? I'm not quite sure what you mean by that - onboard the PLC? Within KEPServer, the "device" (that is, the PLC in question) has been configured for SERIAL1, is that what you mean? Make sure that onboard the PLC the KepServer is configured for SERIAL1. Thanks for all the ideas! I'll go through them one at a time. ![]() I'm using 9600 baud rate, even parity, 1 stop bit - as far as I can see they're uniform across the KEP server and the Quantum.Ĭan anyone suggest what I could try next? Do I need to configure the serial port in the PV itself somehow? My cable is a straight-through 9 pin D shell (pin 1 to pin 1, pin 2 to pin 2, etc.) pfe file is correct, etc, but something in my communications setup is wrong, or my cable is the wrong one. It appears that the PV knows where to look (it has the channel and device name correct, so obviously my. When I run the application on the PV, though, I get the error bar with ". So I have KEP Server installed and configured, I have updated the firmware on the PV to include the KEP drivers, and to the best of my knowledge, the PLC port is configured correctly (although I've never configured a Modbus port on a PLC before, so if anyone knows any hints, traps or otherwise useful info, please let me know). Actually, I have two PLC's, a Schneider 984 and a Schneider Quantum, but I'll start with one at a time. I have a panelview plus 1000 a modbus PLC that I want to use it with. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |